The correct method for using neodymium iron boron magnets

1. Peeling method
During the process of thickness magnetization, it cannot be directly peeled off because one of its main characteristics is hard and brittle. When using relatively brittle magnets, it cannot be directly peeled off with force to avoid breakage caused by poor or excessive force. Once broken, it cannot be used again and may cause accidental injury.
2. Pushing method
Magnets with thick magnetization need to be pushed away, as these magnets are too strong and can easily pinch hands. Push them as much as possible, and there are also methods of pushing and squeezing. When pushing, make sure to push it away with parallel force to avoid being forcefully squeezed or damaged. Usually, larger magnets should be handled by the manufacturer as much as possible. Usually, environmentally friendly paper is used to separate the magnets, in order to avoid wasting time, energy, and easily injuring people during use. Therefore, when using the magnet, it is important to push it away according to the prescribed method.
3. Placement method
If it is a pair of magnetized neodymium iron boron magnets, they must be placed in pairs and placed with caution. Don't let it lose its magnetism. Once the magnetism is lost, it cannot be applied anymore, and at this point it needs to be replaced.
4. Avoiding collisions
During use, it is important to note that its material is prone to becoming brittle, so special care should be taken to avoid collisions. If it accidentally falls to the ground, it can easily be broken or blistered, so it cannot be used again.
Therefore, when using neodymium iron boron magnets with different magnetization methods and magnetic strength, it is important to pay attention to their usage. Although they are strong magnets, they are also very brittle, so it is better to be careful.